Spaguard Soft Soak Chlorinating Granules (2 lb)

Spaguard Soft Soak Chlorinating Granules (2 lb)

Price

$28.99 $0.00
( / )
Soft Soak Chlorinating Granules (2 lb) is a one step sanitizer and oxidizer for spas and hot tubs. Sanitize your water with this product by adding directly to the spa water.Product Dosage1/2 tsp per 100 gallons of water repeated every 15 minutes until chlorine residual of 3-5 ppm is achieved.DirectionsPre...
  • 2 LB
Inventory:

5 in stock.

Soft Soak Chlorinating Granules (2 lb) is a one step sanitizer and oxidizer for spas and hot tubs. Sanitize your water with this product by adding directly to the spa water.

Product Dosage

1/2 tsp per 100 gallons of water repeated every 15 minutes until chlorine residual of 3-5 ppm is achieved.

Directions

Pre Treatment:

Ensure all spa and tub equipment is working properly.
Backwash or clean the filter system following manufacturers directions.
Adjust pH to between 7.2-7.6.
When using other products as outline in the directions for this product, always follow directions on those products.
Spas should be drained and cleaned at least every 60 days or whenever water becomes difficult to manage or keep clear.
Both oils, salts and lotions should not be used unless specifically formulated for use in spas and hot tubs as they can lead to cloudy water.
Routine Maintenance:

With pump on, add 1/2 teaspoon of this product per 100 gallons of water as an initial treatment.
Repeat at 15 to 20 minute intervals until a residual of 3-5 ppm of available chlorine is established as determined by test kit.
A test kit must be used regularly to determine the frequency of additional doses of this product needed to maintain the chlorine residual of 3-5 ppm.
Ingredients

Sodium Dichloro-s-Triazinetrione: 99%, Other Ingredients: 1%
Soak Soak Chlorinating Granules are not compatible with SpaGuard Soft Soak or other Non-Chlorine Hot Tub Chemicals

For more information on Spa Guard products, please watch this informational video.

PRODUCT FAQ'S

The force and velocity of aerated water keeps water moving so the filter can remove suspended debris. Circulation also ensures that the chemicals are thoroughly distributed. Dead spots are usually not as prevalent in a spa as they are in a pool.

With the dirt, sweat and oils released in a spa, good filtration is essential. Cartridge filters are the typical choice and because of the increase in the amount of filterable debris, the filter should be regularly cleaned with a garden hose or chemically cleaned at refill.

Cleaning a spa involves several aspects of care, including the removal of obvious debris by skimming or vacuuming, and removal of body oils that are rinsed off bathers. Also, be sure to wipe surfaces after heavy use.

Bacteria and algae grow much faster in a spa than in a pool. As a result, spa owners need to follow a regular and complete chemical treatment routine. Spa chemistry includes water balance, sanitizer and oxidizer applications.

Fewer gallons of water mean changes in water balance happen faster. Add to this the aerated water, increased water temperature, and the heavier bather loads, and it’s easy to see the importance of regular testing. Adjust the balance and sanitizer levels as needed.

Sooner or later, the water reaches a point where it just gets “worn out” from the bather load. When the water looks bad, smells bad, and feels bad it’s time for a change. It is recommended that you drain and refill your spa with fresh water approximately every 3 months.